How to Connect EXVIST HDMI Encoder to WiFi: SSID and Wireless Setup

WiFi of Encoder

Configure WiFi

  1. Go to Setting-->Network-->WiFi-->Double Click Trusted SSID 
  2. Enter correct password to SSID and Click “Save” 
  3. Refresh and Link Status will be shown “Connected” below which means it’s already connected to WiFi. If disconnected, please try it again or check whether MAC address of this encoder is in the whitelist of your router.
Info
🧙TIPS:
  1. SSID name, which is the network name for a wireless network, should only contain numbers and English letters. If non-standard characters or symbols are used, it may lead to connection issues.
  2. Additionally, the encoder needs to be rebooted by unplugging the Ethernet cable and powering it off. This suggests that the encoder requires a full reboot in order to properly activate the WiFi functionality.

Learn more about FAQs of WiFi

  1. FAQs: WiFi of Encoder


    • Related Articles

    • FAQs: WiFi of Encoder

      Why is it failed to connect to WiFi? To troubleshoot the issue, you can try following steps: Ensure that the SSID (WiFi network name) consists of a combination of alphabets in English and numbers only. Double-check if the password entered for the ...

    • FAQs: RTMP of Encoder

      What's RTMP? RTMP stands for Real-Time Messaging Protocol. It is a streaming protocol developed by Adobe Systems for transmitting audio, video, and data over the internet in real-time. RTMP is commonly used for live streaming and interactive ...

    • Introduction of Encoder

      What's HDMI Video Encoder? An HDMI video encoder is a device or hardware component that is designed to convert video and audio signals from HDMI sources, such as cameras, gaming consoles, or other video playback devices, into digital formats that can ...

    • Device Manager of Encoder

      What is the Device Manager? The Device Manager is a tool for managing EXVIST encoder decoder in your local area network, it's just designed for below features: Searching encoders in the attached network; Quickly modifying IP addresses in batch; ...

    • Maintain of Encoder

      Maintain Go to Setting->System->Maintain Item Description System reboot Click "System reboot" to reboot the encoder System default Click "System default" to reset the encoder to the default factory settings Upgrade Strongly recommended to do ...