How to Configure IPC Disk Settings for Efficient Storage Management | Network Camera

Disk of IP Camera

Disk

  1. Go to Configuration->Storage->Disk

Explanation

  1. Status field shows the status of the current storage the camera is using. 
  2. Formatted shows the storage formatting status: Unformatted, or formatted. 
  3. Usage status shows the diagram of the storage usage status. 
  4. Refresh: Refresh the display of the settings’ value. 
  5. Format: Format the Disk
Info
🧙Tips: If there is SD/USB supported in the camera, please be noted that:
  1. Recommend SD card class 10
  2. Recommend insert the SD card first then turn on the IP Camera
  3. SD card must be formatted as FAT32. IP Camera will not recognize NTFS format.



    • Related Articles

    • Schedule of IP Camera

      In this section, you're learn how to change recording Schedule settings. Record Go to Configuration->Storage->Schedule->Record This tab is where the user can change Record parameter settings. Below is a screenshot of the record tab in Schedule menu. ...

    • Basic Settings of IP Camera

      Basic Settings Overview The Basic Settings page serves as a shortcut center for the most frequently used camera configurations, such as time synchronization, user accounts, and network parameters. It allows users to quickly access these settings ...

    • General of IP Camera

      General Overview The General Settings page provides basic device identification and core feature configuration options. Here you can customize the camera's display name and control the Mobile P2P remote access feature. Configuration Options Settings ...

    • CGI & Postman User Guide of Network Camera

      Overview This guide explains the generic workflow for interacting with your network camera’s CGI interface using Postman. The same method applies to any CGI‑based configuration – audio, video, network, events, PTZ, etc. If you are looking for a ...

    • Quick Start: Connect to AView Mobile App for Network Camera

      ⏱️ Before You Start PoE Camera: Power on and wait ~5 minutes before scanning the QR code to ensure P2P ID is ready. WiFi Camera (AP mode): Power on only (no Ethernet cable). Wait ~1 minute for SSID HSIPC-XXXXXX to appear. If not visible, press and ...