VoIP of IP Camera

VoIP

1. Go to Configuration->Network->VoIP
   

VoIP stands for Voice over Internet Protocol. This technology is used to transmit the IP video and voice between the VoIP server and the cameras. Below is a snapshot of VoIP tab.

Explanation

1. Enable: This dropdown box allows the user to enable VoIP functionality. 
2. Authentication: This dropdown box allow the user to enable VoIP authentication. 
3. Server address: This field allows the user to fill out the VoIP server address. 
4. Port: This field allows the user to fill out the VoIP server port. 
5. Call ID: This field allows the user to fill out the camera call ID number registered. 
6. Username: This field allows the user to fill out the username in the VoIP system. 
7. Password: This field allows the user to fill out the password in the VoIP system. 
8. Stream type: This dropdown box allows the user to select the stream type in the VoIP system. 
9. Max. call duration: This field allows the user to fill out the VoIP call maximum duration time. 
10. Restore Default: Restore the values to default setting. 
11. Refresh: Refresh the display of the settings’ value. 
12. Save: Save the settings.
    

• Related Articles

• Model Comparison of Network Camera

  Bullet | 2x LED | Fixed Lens Series Part Number ZSC8PSH16F ZSC8WSH16F ZSC5PSH16F ZSC5WSH16F ZSC3PSH16F ZSC3WSH16F Type 4K(8MP) PoE 4K(8MP) WiFi 5MP PoE 5MP WiFi 3MP PoE 3MP WiFi Light Mode IR or Dual Light(IR+WARM) Dual Light(IR+WARM) Resolution ...

• Basic Settings of IP Camera

  Basic Settings Overview The Basic Settings page serves as a shortcut center for the most frequently used camera configurations, such as time synchronization, user accounts, and network parameters. It allows users to quickly access these settings ...

• General of IP Camera

  General Overview The General Settings page provides basic device identification and core feature configuration options. Here you can customize the camera's display name and control the Mobile P2P remote access feature. Configuration Options Settings ...

• CGI & Postman User Guide of Network Camera

  Overview This guide explains the generic workflow for interacting with your network camera’s CGI interface using Postman. The same method applies to any CGI‑based configuration – audio, video, network, events, PTZ, etc. If you are looking for a ...

• Quick Start: Connect to AView Mobile App for Network Camera

  ⏱️ Before You Start PoE Camera: Power on and wait ~5 minutes before scanning the QR code to ensure P2P ID is ready. WiFi Camera (AP mode): Power on only (no Ethernet cable). Wait ~1 minute for SSID HSIPC-XXXXXX to appear. If not visible, press and ...