Setting Up PPPoE on IPC Cameras: Network Configuration Guide

PPPoE of IP Camera

PPPoE

  1. Go to Configuration->Network->PPPoE
PPPoE stands for Point-to-Point protocol over Ethernet. This feature allows the user to configure PPPoE connections. Below is a screenshot of the PPPoE screen.

Explanation

To enable PPPoE, click the enable checkbox, and fill in the username and password fields, then click Save.
  1. Connection status: PPPoE connection status: connected or not connected. 
  2. IP address: The IP address the camera obtained. 
  3. Restore Default: Restore the values to default setting. 
  4. Refresh: Refresh the display of the settings’ value. 
  5. Save: Save the settings.

    • Related Articles

    • TCP/IP of IP Camera

      Network Status Go to Configuration->Network->TCP/IP->Tab "Network Status" The tab shows the current network status of the camera including the IPV4, IPV6 and Wireless network status. Below is a screenshot of the Network status tab: TCP/IP Go to ...

    • Model Comparison of Network Camera

      Bullet | 2x LED | Fixed Lens Series Part Number ZSC8PSH16F ZSC8WSH16F ZSC5PSH16F ZSC5WSH16F ZSC3PSH16F ZSC3WSH16F Type 4K(8MP) PoE 4K(8MP) WiFi 5MP PoE 5MP WiFi 3MP PoE 3MP WiFi Light Mode IR or Dual Light(IR+WARM) Dual Light(IR+WARM) Resolution ...

    • Basic Settings of IP Camera

      Basic Settings Overview The Basic Settings page serves as a shortcut center for the most frequently used camera configurations, such as time synchronization, user accounts, and network parameters. It allows users to quickly access these settings ...

    • General of IP Camera

      General Overview The General Settings page provides basic device identification and core feature configuration options. Here you can customize the camera's display name and control the Mobile P2P remote access feature. Configuration Options Settings ...

    • Quick Start: Connect to AView Mobile App for Network Camera

      ⏱️ Before You Start PoE Camera: Power on and wait ~5 minutes before scanning the QR code to ensure P2P ID is ready. WiFi Camera (AP mode): Power on only (no Ethernet cable). Wait ~1 minute for SSID HSIPC-XXXXXX to appear. If not visible, press and ...