Abnormality of IP Camera
Network Disconnection
- Go to Configuration->Event->Abnormality->Network Disconnection
This tab allows the user to set the camera’s response to a Network disconnection related abnormality. Below is a screenshot of the Network disconnection tab screen:
Explanation
- Enable: This checkbox enables the Network abnormality trigger for the camera.
- Trigger interval Min. time: This field allows the user to fill out the alarm triggered interval minimum time.
- Alarm output: This checkbox allows the user to enable the camera to send the alarm notification output when a motion detection alarm is triggered.
- Record: This checkbox allows the user to enable the camera to record video when a motion detection alarm is triggered.
- Snapshot: This checkbox allows the user to enable the camera to take a snapshot when a motion detection alarm is triggered.
- Audio out: This checkbox allows the user to enable the camera to activate speaker sounds when a motion detection alarm is triggered.
- Restore Default: Restore the values to default setting.
- Refresh: Refresh the display of the settings’ value.
- Save: Save the settings
Device Startup
- Go to Configuration->Event->Abnormality->Device Startup
This tab allows the user to set the camera’s response to a Device start up related abnormality. Below is a screenshot of the Device startup tab screen:
Explanation
- Alarm output: This checkbox allows the user to enable the camera to send the alarm notification output when a motion detection alarm is triggered.
- Record: This checkbox allows the user to enable the camera to record video when a motion detection alarm is triggered.
- FTP: This checkbox allows the user to enable the camera to upload the video and snapshot to the FTP server when a motion detection alarm is triggered.
- Send Email: This checkbox allows the user to enable the camera to send an email when a motion detection alarm is triggered.
- Snapshot: This checkbox allows the user to enable the camera to take a snapshot when a motion detection alarm is triggered.
- Audio out: This checkbox allows the user to enable the camera to activate speaker sounds when a motion detection alarm is triggered.
- Notify the event server: This checkbox allows the user to enable the camera to send the alarm notification to the specified event server when a motion detection alarm is triggered.
- Restore Default: Restore the values to default setting.
- Refresh: Refresh the display of the settings’ value.
- Save: Save the settings.
Related Articles
Basic Settings of IP Camera
Basic Settings Overview The Basic Settings page serves as a shortcut center for the most frequently used camera configurations, such as time synchronization, user accounts, and network parameters. It allows users to quickly access these settings ...General of IP Camera
General Overview The General Settings page provides basic device identification and core feature configuration options. Here you can customize the camera's display name and control the Mobile P2P remote access feature. Configuration Options Settings ...CGI & Postman User Guide of Network Camera
Overview This guide explains the generic workflow for interacting with your network camera’s CGI interface using Postman. The same method applies to any CGI‑based configuration – audio, video, network, events, PTZ, etc. If you are looking for a ...Quick Start: Connect to AView Mobile App for Network Camera
⏱️ Before You Start PoE Camera: Power on and wait ~5 minutes before scanning the QR code to ensure P2P ID is ready. WiFi Camera (AP mode): Power on only (no Ethernet cable). Wait ~1 minute for SSID HSIPC-XXXXXX to appear. If not visible, press and ...IP Filter of IP Camera
IP Filter Go to Configuration->Security->IP Filter This screen allows for the filtering of IP addresses, either blocking them, or granting them access to the camera. This feature helps make the camera more secure by limiting remote access only to ...