Introduction of Router V519

Introduction of Router V519

Brief Introduction

Thank you so much for purchasing our 4G LTE industrial routers. V519-industrial 3G/4G router-adopts high performance 32-bit processor, high speed process protocol and large data, equipped with multiply 3G/4G industrial modules(WCDMA/EVDO/TD-SCDMA/FDD-LTE/TDD-LTE), provides 10/100M adaptive ethernet port, WiFi wireless port, serial port, integrated with multiply terminal devices,easy to do configuration via WEB and remote control.

Features

  1. Wide Voltage Input DC7V-35V With Auto Power-Off Protection;
  2. Site Control, Port Mapping, DMZ Host etc.;
  3. IEEE 802.11 b/gn, Max. Transmission Rate: 300Mbps;
  4. Wireless Video Surveillance and Dynamic Image Transmission Supported;
  5. CDMA, WCDMA, GSM, TD-SCDMA, EVDO, TDD-LTE, FDD-LTE etc. Supported;
  6. Serial Port, TCP/UDP Pass-Through Data Transmission and AT Command Interactive Transmission;
  7. Cloud Control, Auto Upgrade Supported;
  8. VPN, VPDN, PPTP Client, L2TP Client Supported
  9. Auto Network Detection, Dial Failure Auto Reboot, Timing Reboot etc. Supported;
  10. Wired Connection, 4G Network Backup, Auto Switch Between Wired Connection & 4G Network;
  11. Hardware & Software Watchdog Crashproof Design, Running Stably;

    • Related Articles

    • Device of Router V519

      Device In this section, it allows the user to change the operation mode and language. Please check below details: Operation Mode 5x operation modes can be selected: LTE Gateway (By Default), Gateway, 2.4G WISP, AP, Mix. Please see below photo: LTE ...

    • Uninittab of Router V519

      Uninittab In this section, it allows the user to configure close port when powering off the router, but it's not recommended to do that because it's for debugging only. Please check below details:

    • Dashboard of Router V519

      Dashboard In this section, it allows the user to check status of router which you can easily see whether it's connected to the Internet successfully. Please check below details: Click the registered courier and you will see the detailed information ...

    • Auto Reboot of Router V519

      Auto Reboot In this section, it allows the user to set reboot mode. The router will run slowly for a long time. To prevent router failure, it is recommended to set the router to automatically restart. The default factory setting is idle restart, and ...

    • Interfaces of Router V519

      Hardware Interfaces Front Side RJ45 Jack: LAN0 RJ45 Jack: LAN1 DC Jack: DC7V~35V wide voltage, DC12V is better and recommended. ?Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ ...