Auto Reboot of Router V519

Auto Reboot of Router V519

Auto Reboot

In this section, it allows the user to set reboot mode. The router will run slowly for a long time. To prevent router failure, it is recommended to set the router to automatically restart. The default factory setting is idle restart, and the user can set the restart mode according to actual usage. Please check below details:

    • Related Articles

    • Device of Router V519

      Device In this section, it allows the user to change the operation mode and language. Please check below details: Operation Mode 5x operation modes can be selected: LTE Gateway (By Default), Gateway, 2.4G WISP, AP, Mix. Please see below photo: LTE ...

    • Introduction of Router V519

      Brief Introduction Thank you so much for purchasing our 4G LTE industrial routers. V519-industrial 3G/4G router-adopts high performance 32-bit processor, high speed process protocol and large data, equipped with multiply 3G/4G industrial ...

    • LTE of Router V519

      LTE In this section, it allows the user to configure LTE. By default, it’s LTE Gateway mode for V519, just inserting 4G/3G SIM card, later router will auto recognize and register to corresponding network of 4G/3G. You can also configure and select ...

    • Interfaces of Router V519

      Hardware Interfaces Front Side RJ45 Jack: LAN0 RJ45 Jack: LAN1 DC Jack: DC7V~35V wide voltage, DC12V is better and recommended. ?Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ ...

    • FAQs: Upgrade of LTE Router V519

      LTE Router Upgrade Procedure via Telnet (Forced Upgrade Method) Download Toolkit LTE Router Upgrade Procedure via Telnet (Forced Upgrade Method) Preparation Steps: 1. Assign the IP address 192.168.8.10 to your computer. 2. Disable the firewall on ...