Port Map of Router V519

Port Map of Router V519

Port Map

In this section, it allows the user to do port mapping so that users on the external network can directly acess the services provided by the internal service through the router's external IP and port. Please check below details:
Info
🧙Tips: Before doing port mapping, please close the firwall of this router first.

    • Related Articles

    • LTE GPS of Router V519

      LTE GPS In this section, it allows the user to set LTE GPS. LTE GPS is one of optional features because it uses the GPS built-in the 4G modules. If it’s required to enable GPS, please go to Network-->LTE-->GPS and enable GPS. If it positions ...

    • Introduction of Router V519

      Brief Introduction Thank you so much for purchasing our 4G LTE industrial routers. V519-industrial 3G/4G router-adopts high performance 32-bit processor, high speed process protocol and large data, equipped with multiply 3G/4G industrial ...

    • Uninittab of Router V519

      Uninittab In this section, it allows the user to configure close port when powering off the router, but it's not recommended to do that because it's for debugging only. Please check below details:

    • Device of Router V519

      Device In this section, it allows the user to change the operation mode and language. Please check below details: Operation Mode 5x operation modes can be selected: LTE Gateway (By Default), Gateway, 2.4G WISP, AP, Mix. Please see below photo: LTE ...

    • Interfaces of Router V519

      Hardware Interfaces Front Side RJ45 Jack: LAN0 RJ45 Jack: LAN1 DC Jack: DC7V~35V wide voltage, DC12V is better and recommended. ?Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ ...