Hosts of Router V519

Hosts of Router V519

Hosts

In this section, it allows the users to name host for different servers and match the corresponding IPs. In this way can we be easier to access the server by typing in the host name. Please check below details:
Info
🧙Tips: In the local area network of many organizations, there will be servers for users to use. However, since DNS servers are rarely set up in the local area network, when accessing these servers, it is necessary to enter the IP address which is difficult to remember. This is quite troublesome for many people. You can give these servers a name that is easy to remember, and then set up IP mapping in Hosts, so that when you visit later, you only need to enter the name of the server.

    • Related Articles

    • Device of Router V519

      Device In this section, it allows the user to change the operation mode and language. Please check below details: Operation Mode 5x operation modes can be selected: LTE Gateway (By Default), Gateway, 2.4G WISP, AP, Mix. Please see below photo: LTE ...

    • Uninittab of Router V519

      Uninittab In this section, it allows the user to configure close port when powering off the router, but it's not recommended to do that because it's for debugging only. Please check below details:

    • Dashboard of Router V519

      Dashboard In this section, it allows the user to check status of router which you can easily see whether it's connected to the Internet successfully. Please check below details: Click the registered courier and you will see the detailed information ...

    • Auto Reboot of Router V519

      Auto Reboot In this section, it allows the user to set reboot mode. The router will run slowly for a long time. To prevent router failure, it is recommended to set the router to automatically restart. The default factory setting is idle restart, and ...

    • Interfaces of Router V519

      Hardware Interfaces Front Side RJ45 Jack: LAN0 RJ45 Jack: LAN1 DC Jack: DC7V~35V wide voltage, DC12V is better and recommended. ?Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ ...