Uninittab of Router V519

Uninittab

In this section, it allows the user to configure close port when powering off the router, but it's not recommended to do that because it's for debugging only. Please check below details:

• Related Articles

• Device of Router V519

  Device In this section, it allows the user to change the operation mode and language. Please check below details: Operation Mode 5x operation modes can be selected: LTE Gateway (By Default), Gateway, 2.4G WISP, AP, Mix. Please see below photo: LTE ...

• Dashboard of Router V519

  Dashboard In this section, it allows the user to check status of router which you can easily see whether it's connected to the Internet successfully. Please check below details: Click the registered courier and you will see the detailed information ...

• Interfaces of Router V519

  Hardware Interfaces Front Side RJ45 Jack: LAN0 RJ45 Jack: LAN1 DC Jack: DC7V~35V wide voltage, DC12V is better and recommended. ?Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ ...

• Introduction of Router V519

  Brief Introduction Thank you so much for purchasing our 4G LTE industrial routers. V519-industrial 3G/4G router-adopts high performance 32-bit processor, high speed process protocol and large data, equipped with multiply 3G/4G industrial ...

• LTE of Router V519

  LTE In this section, it allows the user to configure LTE. By default, it’s LTE Gateway mode for V519, just inserting 4G/3G SIM card, later router will auto recognize and register to corresponding network of 4G/3G. You can also configure and select ...