Crontab of Router V519

Crontab of Router V519

Crontab

In this section, it allows the user to configure timing task like when it's needed to call that port but it's not recommended to do that because it's used for debugging only. Please check below details:

    • Related Articles

    • Device of Router V519

      Device In this section, it allows the user to change the operation mode and language. Please check below details: Operation Mode 5x operation modes can be selected: LTE Gateway (By Default), Gateway, 2.4G WISP, AP, Mix. Please see below photo: LTE ...

    • Uninittab of Router V519

      Uninittab In this section, it allows the user to configure close port when powering off the router, but it's not recommended to do that because it's for debugging only. Please check below details:

    • Dashboard of Router V519

      Dashboard In this section, it allows the user to check status of router which you can easily see whether it's connected to the Internet successfully. Please check below details: Click the registered courier and you will see the detailed information ...

    • Auto Reboot of Router V519

      Auto Reboot In this section, it allows the user to set reboot mode. The router will run slowly for a long time. To prevent router failure, it is recommended to set the router to automatically restart. The default factory setting is idle restart, and ...

    • Interfaces of Router V519

      Hardware Interfaces Front Side RJ45 Jack: LAN0 RJ45 Jack: LAN1 DC Jack: DC7V~35V wide voltage, DC12V is better and recommended. ?Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ ...