Serial#1 of Router V519

Serial#1

In this section, it allows the user to configure serial port. But only 1ch RS232 can be supported. RS485 can be customized if required. The serial port can also be worked as GPS positioning, terminal command line, ModBus, data transparent transmission. Please check below details:

• Related Articles

• Interfaces of Router V519

  Hardware Interfaces Front Side RJ45 Jack: LAN0 RJ45 Jack: LAN1 DC Jack: DC7V~35V wide voltage, DC12V is better and recommended. ?Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ ...

• Introduction of Router V519

  Brief Introduction Thank you so much for purchasing our 4G LTE industrial routers. V519-industrial 3G/4G router-adopts high performance 32-bit processor, high speed process protocol and large data, equipped with multiply 3G/4G industrial ...

• Device of Router V519

  Device In this section, it allows the user to change the operation mode and language. Please check below details: Operation Mode 5x operation modes can be selected: LTE Gateway (By Default), Gateway, 2.4G WISP, AP, Mix. Please see below photo: LTE ...

• Uninittab of Router V519

  Uninittab In this section, it allows the user to configure close port when powering off the router, but it's not recommended to do that because it's for debugging only. Please check below details:

• Dashboard of Router V519

  Dashboard In this section, it allows the user to check status of router which you can easily see whether it's connected to the Internet successfully. Please check below details: Click the registered courier and you will see the detailed information ...