Quick Start of 4K Extender
Wiring Method
- Connect HDMI signal source to the port "HDMI IN" of Transmitter;
- Connect the port "HDMI OUT" of Receiver to the monitor or TV via HDMI cable;
- Power on Transmitter(TX) & Receiver(RX), After about 40 seconds, the RUN indicator will flash continuously to indicate that images are being transmitted.
🧙Tips: HDMI IN is the signal input, HDMI OUT is connected to the monitor or TV, connect the HDMI cable, and the image will appear about 40 seconds after powering on. The RUN indicator light will flash continuously to indicate that the image is being transmitted.
Connection Diagram(1-TO-1)
Connection Diagram(1-TO-MORE)
🧙Tips: At most 10x RXs for 1x TX. If it's required to add more RXs when 1-to-1, please follow the below instructions to do pairing TX and RXs simultaneously.
Pairing Method
Pairing Method for 1-to-1 Transmitter and Receiver:
- Power on both the TX (transmitter) and RX (receiver) devices and connect them to the HDMI signal source.
- Connect the TX to the RX using an ethernet cable. When the RUN indicator on both devices keeps flashing, it indicates that pairing is successful.
- After successful pairing, unplug the ethernet cable to enable wireless transmission between the TX and RX.
Pairing Method for 1-to-More (Up to 10x RX) Transmitter and Multiple Receivers:
- Based on the 1-to-1 pairing method, all additional RX devices should be paired to the TX one by one when powering on.
- After each RX is successfully paired, unplug the ethernet cable from each RX. It then takes approximately 40 seconds for wireless transmission to establish between the TX and all paired RX devices.
By default, the devices are typically pre-paired before shipment. However, if they are restored to default factory settings or if you're adding more RX devices, following the above instructions for pairing is necessary.
🧙Tips: Make sure the signal source is connected before pairing, otherwise the pairing may fail.