How to Adjust Bitrate on 4K HDMI Extenders | Exvist Support

Adjust Bitrate for 4K Extender

Adjusting Bitrate for Optimal Transmission Performance

In certain scenarios, adjusting the bitrate can improve transmission performance. The bitrate range is 2 Mbps to 8 Mbps, and it should be configured based on actual needs:

Example Scenarios

One-to-Many Mode

  1. It is recommended to lower the bitrate to enhance transmission stability.

One-to-One Mode (Large Screen Display)

  1. It is recommended to increase the bitrate to improve the image clarity on a large screen.

Steps to Adjust Bitrate

Log in to the Management Interface

  1. Open Google Chrome and enter the transmitter’s management IP address: 192.168.1.166, then press Enter.

Access the System Configuration Page

  1. On the login interface, click “System Config”.

Adjust the Encoding Bitrate

  1. Click “Encode Config”.
  2. Select and adjust the bitrate size as needed (unit: Mbps).
By following these steps, you can adjust the bitrate as needed to ensure optimal transmission quality and stability.

    • Related Articles

    • Adjust Bitrate for 1080P Extender

      Adjusting Bitrate for Optimal Transmission Performance In certain scenarios, adjusting the bitrate can improve transmission performance. The bitrate range is 2 Mbps to 8 Mbps, and it should be configured based on actual needs: Example Scenarios ...

    • FAQs: Troubleshooting & Solutions of 4K Extender

      Q1. How do I troubleshoot a black screen on my 4K RX device? If you are experiencing a black screen on your 4K RX device, first check the resolution settings. If the default output resolution is set to 3840x2160p, and the display does not support 4K, ...

    • Quick Start of 1080p Extender

      Wiring Method Connect HDMI signal source to the port "HDMI IN" of Transmitter; Connect the port "HDMI OUT" of Receiver to the monitor or TV via HDMI cable; Power on Transmitter(TX) & Receiver(RX), After about 40 seconds, the RUN indicator will flash ...

    • FAQs: Troubleshooting & Solutions of 1080P Extender

      Q1. How do I troubleshoot a black screen on my 4K RX device? If you are experiencing a black screen on your 4K RX device, first check the resolution settings. If the default output resolution is set to 3840x2160p, and the display does not support 4K, ...

    • Pairing Methods for 1080P Extender

      Pairing Instructions for 1080P Extender 1-to-1 Mode (1x Transmitter and 1x Receiver) 1. Connect the Signal Source to the Transmitter Insert the HDMI signal source into the HDMI IN port on the transmitter(TX). Important: Ensure the signal source is ...