Auto Reboot of Encoder

What's Auto Reboot?

Auto Reboot is a feature that allows the encoder/decoder to be set to automatically restart at a specified time.

Related Articles
FAQs: Auto Reboot of Encoder
Why is there no tab Auto Reboot in our encoder? The absence of an "Auto Reboot" tab in an encoder's settings may be due to a few reasons: Software Version: It's possible that the "Auto Reboot" feature is not available in the current software version ...
WiFi of Encoder
Configure WiFi Go to Setting-->Network-->WiFi-->Double Click Trusted SSID Enter correct password to SSID and Click “Save” Refresh and Link Status will be shown “Connected” below which means it’s already connected to WiFi. If disconnected, please try ...
Maintain of Encoder
Maintain Go to Setting->System->Maintain Item Description System reboot Click "System reboot" to reboot the encoder System default Click "System default" to reset the encoder to the default factory settings Upgrade Strongly recommended to do ...
FAQs: Overview of Encoder
What does 1920*1080P@30HZ mean? If it shows 1920*1080P@30HZ on GUI, probably it's failed to detect the HDMI signal. Take the following steps if there is a failure to detect an HDMI signal. Ensuring that the HDMI cable is properly connected and meets ...
Audio of Encoder
Audio Go to Setting->Video/Audio->Audio Item Description Audio input HDMI or Line-in(3.5mm only) Or Audio Mix Samples 48000 Codec type G.711A/G.711U/AAC; AAC should be enabled by default if it's needed to push live video to YouTube, or else it might ...