Unicast Network Settings for HDMI Codecs | Exvist Support

Unicast of Codec

Unicast

  1. Go to Setting->Network->Unicast
Item
Description
Main Stream
Enable: Check the checkbox;
Unicast address: 192.168.1.3;
Port: change port if required;
Sub Stream
Enable: Check the checkbox;
Unicast address: 192.168.1.3;
Port: Change port if required;

    • Related Articles

    • Overview of Codec

      Overview Click Setting and it'll show you the Overview of current status of encoder as below: NOTES: You can also read more about Channel of Codec. Learn more about FAQs of Overview FAQs: Overview of Codec
    • System Setting of Codec

      SS50 | SS52 MS7 Codec Series System Settings Go to Setting->System Setting->Change "Device Name" or Upload "Boot Logo" or "Video Lost Picture" if required Configure HDMI output resolution by scrolling down to desired resolution from Video Output ...
    • FAQs: Channel of Codec

      SS50 MS7 Codec Series What is the decoding capacity of this codec in terms of channels? This codec can decode a maximum of four channels, which can be configured as 2x USB camera and 2x network streams, or 1x USB camera and 3x network streams, or ...
    • FAQs: Image of Codec

      Why is there no preview in the Image Settings Page on my HDMI Codec? If you can't see a preview in the image settings page on your HDMI codec, it's likely due to using an outdated firmware version. Here’s how to address the issue: 1. Firmware ...
    • FAQs: WiFi of Codec

      Why is it failed to connect to WiFi? To troubleshoot the issue, you can try following steps: Ensure that the SSID (WiFi network name) consists of a combination of alphabets in English and numbers only. Double-check if the password entered for the ...